Whether the stainless steel round pipe polishing machine can operate safely according to the regulations is the priority among priorities to ensure the construction safety and civilized construction. Stainless steel round tube polishing machine safe operation is not only responsible for polishing object, responsible for the life of the people, the rationalization of action, standardized use, only with strict accordance with the procedure, to ensure that the polishing machine is good to complete the work, but also to ensure the safety of construction personnel. The following polisher operating procedures need to be remembered.
Stainless steel round tube polishing machine before use. The first step is to check the circuit. This is the first step before starting the machine. Wires, sockets and plugs are in good condition. There's no danger of shock. It's a necessary check.
As a qualified builder, if you are in the polishing process with oily hands or wet hands and then make a big mistake, it is not good and there is an electric shock hazard.
If you are not a professional maintenance personnel, it is not possible to dismantle the pipe tube polishing machine, can only manage daily maintenance. The power cord of the polishing machine shall not be modified without permission, and the length of the power cord shall not be greater than 5 cm. The protective cover of the pipe tube polishing machine is damaged and should be replaced immediately.
After the stainless steel round tube polishing machine is used, it shall be managed by special personnel and recorded to ensure the next use of the polishing machine.
Round tube polishing machine maintenance instructions:
- Appearance maintenance: stainless steel tube polishing machine appearance and motor, heat dissipation equipment appearance must be kept clean, regular finishing polishing powder. Check and tighten handles, feed handwheels, screws, nuts and other parts. Keep the machine intact.
- Check the whole steel tube polishing machine: check the screw, belt and tightness of each part of the steel tube polishing machine, loose should be adjusted to the appropriate stop. Check the wear degree of each bearing if there is damage should be replaced, lubricating oil is sufficient. The guide rail should be cleaned and clean. Polishing consumable powder is not allowed on the guide rail.
- Electrical appliances: clean the motor and electrical box regularly. The electrical equipment is fixed and regular, and the action is firm. Check and tighten the zero connection equipment.
